Hey everyone,
I've been going through and printing all the town building & street exterior walls and I noticed that, unlike the other sets I've noticed (cave, dungeon, etc) there are no 'Point 1 walls'. Is this an issue? the advice I've read from the print list is that you should print 5 x point 1 walls for each set. Should I be using point 1 walls from a different set (castle?) when building a room with the indoor floor hexes, or is this really not an issue and you can make indoor maps work just using larger point walls?
Thanks very much for your help! This was my mistake: after your response I looked into it and realized that I never actually downloaded thee "Indoor + Stretch Goals" files; I was just looking at the files from the for thee intrerior/exterior walls. Now I've got what I need!
Hi Jesse,
There are in fact a number of Point 1 Wall options available to you in the 'Indoor + Stretch Goals' download;
Indoor Point Walls
TST WL-PT1 ID1 [Supported and non-supported versions]
This is the obvious choice for an indoor themed wooden floorboard layout, as there is no floor hex texture featured on this design so it will match anywhere you put it.
Stretch Goal - Shop & Market Walls
TST WL-PT1 MKT (Banners) [Supported and non-supported versions]
TST WL-PT1 MKT CBL (Barrel Table Plain) [Supported and non-supported versions]
TST WL-PT1 MKT CBL (Weapon Table) [Supported and non-supported versions]
Some images of these below.
There are also Point 1 Wall versions contained in the cemetery, castle and sewer packs.
Hope this helps,
Jay