Hi guys I'm new to the world of 3d printing and I recently got my wife and kids into gloomhaven (JOTL) and we just finished it (we had a blast) so now we are about to start gloomhaven in a few weeks and i want to kick it up a bit my 3d printer should be in anyday now and I'm looking to start printing Whats the difference between the All in and the basic pledge I know I'm getting one of them just not sure which one.. And if anyone has any suggestions about where I can get more stuff to print for gloomhaven that would be awesome too.
top of page
bottom of page
Hi Kacee, and welcome! There’s a pretty big difference between the Basic and All In pledges. The basic includes four hex floor types (dungeon, cave, indoor and outdoor) however you only get to choose one theme for your columns, walls, doors and traps (choose from dungeon, cave or outdoor). Also, you don’t get any of the many unlocked stretch goals from the campaign in the Basic pledge. All In gets you the same floor types as above ie dungeon, cave, indoor and outdoor but further, you get ALL dungeon, cave and outdoor themes of walls, columns, doors and traps so you get a lot more room to move in the aesthetic variety in your builds. All In also gets you the many stretch goals which will be finalised and delivered in the coming months eg hex holder storage solution, cave overlays, water hexes, docks, outdoor overlays, palisade/fort fencing, cobblestone streets/pavement, scenic risers and much more. We have a limited time sale for late backers which gets you $15 off the All In pledge. Simply enter’TST15OFF’ at checkout. Hope this helps. Cheers, Jay