So I have been printing floor hexes on my Anycubic iMega SE using default cura settings and ironing and getting great results.
However, I recently got an Ender 3 V3 KE and with the default Cura and ironing settings, I've been getting terrible top surface quality.
Anycubic - good results
The top hex is the V3 KE, bottom is my Anycubic iMega SE
V3 KE
I have tweaked the ironing settings a bit but this is the best I've been able to pull off, better but still not nearly as good or consistent as the iMega... Any recommendations?
Quick follow-up, shortly after I posted this, I used the Orca slicer on default settings and got nearly flawless results!