Anyone else getting ‘warts’ on the edges of some of the rocks on the dungeon tiles with ironing enabled? Thinking of trying with 5% flow rate (down from the 10% standard), unless anyone has other ideas?
Thanks for the info. I did end up having better results with the 5% setting. The extra material wasn’t 100% eliminated, but it’s a lot less and overall looks fine painted up. I think it’s worth it for the smooth stones overall, but only plan on using for the dungeon and cave tiles.
I actually played with the ironing a little bit with some success and some failures. I turned it off for most of the prints and the dungeon walls actually look pretty decent with out it. Although, I do think the errors I had were due to user error and ignorance and not due to having ironing switched on.
Thanks for the info. I did end up having better results with the 5% setting. The extra material wasn’t 100% eliminated, but it’s a lot less and overall looks fine painted up. I think it’s worth it for the smooth stones overall, but only plan on using for the dungeon and cave tiles.
I actually played with the ironing a little bit with some success and some failures. I turned it off for most of the prints and the dungeon walls actually look pretty decent with out it. Although, I do think the errors I had were due to user error and ignorance and not due to having ironing switched on.